Alfa Tube - OpenWRT Firmware

Alfa Tube

Alfa Tube Firmware Please select a model and download firmware. You have to match exact version to prevent issues

Configuring Alfa Tube router with your Start Hotspot account - step by step instructions

Connecting
This article describes installation and configuration steps for Alfa Tube2h router.

Please reset Alfa Tube router to factory settings to avoid problems with some previous configuration.

Connect your computer LAN using cable to router Ethernet port.
Set static IP address in 192.168.1.x range
In the address bar of the web browser, enter 192.168.1.1 and login using admin as username and admin as password.
From the System Management go to Firmware Upgrade section.
Press on Browse button to locate and select firmware file located on your computer
Press onApply button.
It takes about 2~3 minutes to upgrade the firmware.
After that you will need to reconnect LAN cable or to Disable/Enable NIC card in order to get new valid IP address in 192.168.45.x range from router.
Setup

Configuring parameters

Start your browser and in URL field type “http://router:8089”
In our example it is 192.168.45.1:8089
Username : admin
Password : admin
Setup
Press Login button to access to Status tab.
Setup
On Status page you will see a MAC address of your OpenWRT router which will be used in the SignUp process.
After selecting your HotSpot name, select as HotSpot model OpenWRT, and add your MAC address from Status tab.
Setup
From Setup page configure your OpenWRT router.
Be sure that you set Autostart option. This option is not active by default.
When you finish with the settings press Save button on bottom of the page.
Setup


If you need help with configuration, please go to starthotspot.com and contact our tech support. We'll be glad to help you.