Teltonika - OpenWRT Firmware

Teltonika

Teltonika Firmware Please select a model and download firmware. You have to match exact version to prevent issues

Configuring Teltonika router with your Start Hotspot account - step by step instructions

Warning!

This section describes actions that might damage your device or firmware. Proceed with care!

The installation of OpenWrt firmware is device specific.
These device specific procedures should be found in the OpenWrt wiki.
See OpenWrt Table of Hardware for available procedures.
If your device is not listed, information on this page may be helpful.

Connecting


Please reset router to factory settings to avoid problems with some previous configuration.
To log in to Teltonika web interface, open a web browser, enter IP address 192.168.1.1 and type your username and password.
Teltonika
From System menu click Firmware.
Teltonika
From the Firmware Upgrade settings section, untick Keep all settings option.
Teltonika
Select Upgrade from file.
Click Choose File link to upgrade the firmware of the device.
Navigate to the location where the factory version for your model is downloaded and press Open.
To perform this procedure, please prepare appropriate firmware from your model.
Click Upload to complete the firmware upgrade.
Teltonika
When firmware upgrade is completed, open a web browser and enter IP address 192.168.45.1:8080
From Network/WAN page you can determine how the router will be connecting to the Internet.
Select Wired or Mobile Operation mode.
Teltonika
Reconnect LAN cable or to Disable/Enable NIC card in order to get a new valid IP address in 192.168.45.x range from the router.
Do not power off the router during the firmware upgrade, as it can cause the device to crash or become unusable.

Configuring parameters

Start your browser and in URL field type http://192.168.45.1:8089
Username : admin
Password : admin
Setup
Press Login button to access to Status tab.
Cloud StartHotSpot Login page
On Status page you will see a MAC address of your OpenWRT router which will be used in the SignUp process.
After selecting your HotSpot name, select as HotSpot model OpenWRT, and add your MAC address from Status tab.
Cloud StartHotSpot Login page
From Setup page configure your OpenWRT router.
Be sure and set Autostart option.
This option is not active by default.
Here you can set new Administrator password for access to the router setup and configuration.
Save changes.
When you finish setup, restart router to apply changes.
Cloud StartHotSpot Login page


If you need help with configuration, please go to starthotspot.com and contact our tech support. We'll be glad to help you.